Advertisement
Threaded pin
20 mm +/- 3
Position of hook
100 mm +/- 5
Plaster
Threaded pin
Electrical connection
The electrical connection must be
carried out in accordance with the
current standards and laws in force.
Before connecting check that:
• the system and electrical sockets
amperage is adequate for the
appliance maximum power (see
data label affixed on the back of the
cooker).
• the socket or system has an effective
earth connection in accordance with
current standards and prescriptions of
the law. All responsibility is disclaimed
if this is not complied with.
• the plug and socket or the multipolar
switch must be accessible after
installation of the appliance.
When connecting to the mains with a
socket:
• Fit to the power cable (if without) a
standardized plug, suitable for the
load which is indicated on the data
label. Connect the wires making sure
they correspond as shown below, and
remember that the earth wire must
be longer than the phase wires:
timber
Threaded pin
Wall
Until Tilt
Hose Assembly hook
Masonary wall
letter
L (phase) = brown wire
letter
N (neutral) = blue wire
symbol
(earth)
• The power cable must be laid so that
no parts of it ever reach a temperature
of 75 °C.
• For connecting do not use, adapters
or shunts as they could cause false
contacts resulting in hazardous
overheating.
When connecting directly to the
mains:
• Install a multipolar switch that can
withstand the appliance load, with
a minimum opening between the
contacts of 3 mm. Remember that the
earth wire must not be cut out by the
switch.
Adjustments
• Always disconnect the appliance
from the electricity supply before
making any adjustment.
• All seal must be replaced by
the technician following any
adjustment or regulation.
ENGLISH
21
= green/yellow wire
Advertisement
