Universal Dmx Control - ADJ EVENT BAR PRO User Manual

Hide thumbs

Table Of Contents

Table of Contents

Universal DMX Control: This function allows you to use a universal DMX-512 controller to create

unique programs tailored to your individual needs.

The Event Bar Pro has five different DMX channel modes. Refer to the System Menu section of

•

this manual for details on how to set the DMX channel mode. Detailed information on the DMX

traits can be found in the Channel Mode sections of this manual.

To control your fixture in DMX mode, follow the set-up procedures in the DMX Set Up section of

•

this manual, as well as the set-up specifications that are included with your DMX controller.

•

Use the controller's faders to control the various DMX fixture traits. This will allow you to create

your own programs.

Set the DMX address, as detailed in the System Menu section of this manual.

•

For longer cable runs (more than a 100 feet) use a terminator on the last fixture.

•

For help operating in DMX mode consult the manual included with your DMX controller.

This function will allow you to link up to 16 units together and operate without a controller. The units

will be sound activated. IOne unit will act as the controlling unit and the others will react to the con-

trolling unit's programs. Any unit can act as a Primary or as a Secondary.

1. Using approved DMX data cables, daisy chain your units together via the XLR connector on the

rear of the units. Remember the male XLR connector is the input and the female XLR connector

is the output. The first unit in the chain (primary) will use the female XLR connector only, and the

last unit in the chain will use the male XLR connector only. For longer cable runs, we suggest the

use of a terminator at the last fixture.

2. Set the Primary unit to the Primary setting following the instructions in the System Menu section

of this manual. Then set the Primary to your desired operating mode.

3. On the Secondary units, press the MENU button until "Pri/Sec Mode" is displayed, then press

ENTER. Choose either "Sec 1" or "Sec 2" and press ENTER.

4. The Secondary unit(s) will now follow the Primary unit.

Blackout

Function

Mode