ADJ EVENT BAR PRO User Manual page 10

Table of Contents

Advertisement

DMX Address - Set the DMX Address.
1. Press the MENU button until "DMX Addresss" is displayed, then press ENTER.
2. The currently selected address will now be displayed. Press the UP or DOWN buttons to scroll to
your desired address.
3. Press ENTER to confirm, and then press and hold the MENU button for at least three seconds to
assign.
Channel Mode - This will let you select your desired DMX Channel mode.
1. Press the MENU button until "Channel Mode" is displayed, then press ENTER.
2. The currently selected DMX Channel Mode will be displayed. Press the UP or DOWN buttons to
scroll to your desired Channel mode.
3. Press ENTER to confirm.
Pri/Sec Mode - This will let you set your unit as a primary or a secondary in a primary/second-
ary configuration.
1. Press the MENU button until "Pri/Sec Mode" is displayed, then press ENTER. Either "Pri", "Sec
1", or "Sec 2" will be displayed.
2. Press the UP or DOWN buttons until your desired setting is displayed, and press ENTER to con-
fim.
NOTE: If one fixture is set to "Pri", and the next fixture is set to "Sec 2", the fixtures will now have
contrasting movement with respect to each other.
Show Mode - Show modes 0-8 (Factory programs). Show mode can run with or without sound
active mode.
1. Press the MENU button until "Show Mode" is displayed, then press ENTER.
2. The currently selected show number will be displayed. Programs 1-8 are factory programs, while
"Show 0" is random mode. Press the UP or DOWN buttons to find your desired show.
Dimmer Curve - In this mode you can select the dimmer curve. See the Dimmer Curve Chart
section of this manual for the different dimmer curve modes.
1. Press the MENU button until "Dimmer Curve" is displayed, then press ENTER.
2. The current dimmer mode will be displayed.
3. Press the UP or DOWN buttons to find your desired dimmer mode and press ENTER to confirm.
Install Mode - This mode allows you to control the beam spread of the fixture.
1. Press the MENU button until "Install Mode" is displayed, then press ENTER.
2. Either "INS 1", "INS 2" or "INS 3" will be displayed.
• INS 1 - Long range beam (ceiling hanging)
• INS 2 - Short range beam (ceiling hanging)
• INS 3 - Front range beam (for truss or wall mounting)
3. Press the UP or DOWN buttons until your desired installation setting is displayed, and press EN-
TER to confim.
SYSTEM MENU
10

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EVENT BAR PRO and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Table of Contents