Mass Flow - GE DigitalFlow DF868 Programming Manual

Mass Flow

Programming Site Data
Mass Flow
If the prompt in the
this sub-section. However, the following programming sequence
Mass Flow
appears if is enabled.
[F1]-[F4]
1. Use the keys to select the desired Mass Flow units, listed
in Table 1-4 below.
Table 1-4: Available Mass Flow Units
English
LB = Pounds
KLB = Thousands of LB
MMLB = Millions of LB
TONS = Tons (2000 LB)
[F1]-[F4]
2. Use the keys to select the desired Mass Flow Time units.
[F1]-[F4]
3. Use the keys to select the MDOT Decimal Digits (the
digits to the right of the decimal point) for displaying mass flow.
[F1]-[F4]
4. Use the keys to select the Mass (Totalizer) units, listed in
Table 1-4 above.
[F1]-[F4]
5. Use the keys to select the Mass Decimal Digits (the digits
to the right of the decimal point) for displaying totalized mass
flow.
SETUP
submenu is not enabled, skip
Metric
KG = Kilograms
TONNE = Metric Tons (1000 KG)
March 2008
1-13