Setting Up Analog Outputs - GE DigitalFlow DF868 Programming Manual

March 2008

Setting Up Analog Outputs

1-22
The Model DF868 has two built-in analog outputs that are assigned to
Slot 0
. Also, a variety of option cards may be installed in the six
expansion slots. See Chapter 1, Installation, of the Startup Guide for
a complete description of the available option cards.
This menu option is used to set up and/or scale the analog inputs and
outputs. To accomplish this, complete the following steps:
1. At the I/O screen, press
2. Use the [←] and [→] and the
slot number. (Only those slots which contain an option card will
appear on the option bar.)
Note: If the number of a slot with an installed option card does not
appear, the card may not have been initialized or it may be
defective. Call the factory for assistance.
Proceed to the appropriate section for programming instructions
specific to the type of input or output selected above.
[F2]
to select the Optn option.
[F1]-[F4]
keys to select the desired
Programming Site Data