Fluke FiberInspector Pro FI-3000 Abridged User Manual page 17

Inspect an Endface
3. When the LEDs on the probe show the pass ( ) or fail ( )
4. After the probe transmits the test results to your device, the
* The adapter's key position affects the fiber numbers
1.800.561.8187
Insert the probe tip into a bulkhead connector, or into an
adapter attached to a patch cord (Figure 8).
The app shows a live image of the endface. You can adjust the
image as shown in Figure 9.
Press to focus the image if necessary, then press
Test on your mobile device.
result, you can remove the probe from the connector.
app shows the TEST RESULT SUMMARY screen. You can then
Save or the result or tap the endface graphic to see
detailed results. See "Endface Image Screens" on page 17.
To see the live image again, tap
Patch cord
Adapter*
in your test results. See "Set the Key Position" on
page 13.
www.
or Live.
Inspect an Endface
information@itm.com
.com
or tap
CL04.PDF
15