Server TOUCHLESS EXPRESS Quick Start Manual

TOUCHLESS EXPRESS
TIPS AND TRICKS TO HELP YOU GET STARTED
WITH YOUR NEW DIRECT-POUR TOUCHLESS EXPRESS.
Remove unit from box
1
and wash all parts
properly before use.
Clean sensor
window with a
micro ber cloth.
Keep window free of
debris at all times.
4
Install tube by rotating until
both pegs on housing t into
holes on tube.
Fill jar to 1/2-inch below the
6
handle. Put the lid on the jar
and slide into shroud through
the back slide panel.
DO NOT POUR
DIRECTLY INTO
DISPENSER SHROUD.
Fill Point
Jar
Shroud
Plug cord into
9
power outlet and
press switch on.
© 2021 Server Products, Inc.
Squeeze pinch valve open
2
to ensure it isn't stuck
shut and insert into pump
housing.
5
Select medium discharge tting and insert into
discharge tube. Place loop of tting around peg
on end of discharge tube to secure.
7 7
Place pump into
the shroud by
aligning pump
guides into the
slots and the
pick-up tube
through the hole
in the jar lid.
Hand-prime pump
by pressing dome
until product lls
discharge tube.
When starting the unit, it will
10
cycle through three light colors
(red, blue & green). Light will
show blue when the unit is at
rest and ready to go.
WANT TO LEARN MORE?
Consult your manual or visit YouTube.com/ServerProducts
for more videos.
spsales@server-products.com | 800.558.8722
QUICK START GUIDE
™
Press dome into housing fully and wrap loop
3
around lower opening to secure.
8
SHROUD
TABS
11
DIRECT-POUR MANUAL
PART #100275
CONSULT YOUR
MANUAL FOR MORE
TROUBLESHOOTING
INFORMATION.
MANUAL BUTTON
Put lid on shroud by matching lid slots with
shroud tabs. Pull out locking pin to slide
the lid into position and release to lock.
LOCKING
PIN
To prime pump or dispense
manually, press area below
sensor window. Hold hand over
sensor window for touchless
operation and start dispensing!
SENSOR
BWW_TE_DI_DP_100253_InstructionSheet