Advertisement
Switch off the lights.
X
Open the bonnet.
X
Turn housing cover : anti-clockwise and
X
remove it.
Turn bulb holder ; anti-clockwise and pull
X
out.
Pull the bulb out of bulb holder ;.
X
Insert the new bulb into bulb holder ;.
X
Insert bulb holder ; and turn it clockwise.
X
Press on housing cover : and turn it to the
X
right.
Turn signals
Remove the cover in the front wheel arch
X
(
page 124).
Y
Turn housing cover : anti-clockwise and
X
remove it.
Turn bulb holder ; anti-clockwise, unlock it
X
and pull out.
Pull the bulb out of bulb holder ;.
X
Insert the new bulb into bulb holder ;.
X
Insert bulb holder ; and turn it clockwise.
X
Press on housing cover : turn clockwise and
X
lock.
Replace the cover in the front wheel arch
X
(
page 124).
Y
Windscreen wipers
Switching the windscreen wipers on/
off
!
Do not operate the windscreen wipers when
the windscreen is dry, as this could damage
the wiper blades. Moreover, dust that has col-
lected on the windscreen can scratch the
Windscreen wipers
glass if wiping takes place when the wind-
screen is dry.
If it is necessary to switch on the windscreen
wipers in dry weather conditions, always
operate them using washer fluid.
!
If the windscreen wipers leave smears on
the windscreen after the vehicle has been
washed in an automatic car wash, this may be
due to wax or other residue. Clean the wind-
screen with washer fluid after an automatic
car wash.
!
Intermittent wiping with rain sensor: due to
optical influences and the windscreen becom-
ing dirty in dry weather conditions, the wind-
screen wipers may be activated inadvertently.
This could damage the windscreen wiper
blades or scratch the windscreen.
For this reason, you should always switch off
the windscreen wipers in dry weather.
$ Windscreen wipers off
1
Ä Intermittent wipe, low (rain sensor set
2
to low sensitivity)
Å Intermittent wipe, high (rain sensor
3
set to high sensitivity)
° Continuous wipe, slow
4
¯ Continuous wipe, fast
5
í Single wipe
B
î To wipe with washer fluid
Turn the key to position 1 or 2 in the ignition
X
lock (
page 145).
Y
Turn the combination switch to the corre-
X
sponding position.
Vehicles with a rain sensor: in the Ä or
Å position, the appropriate wiping frequency
is automatically set according to the intensity of
the rain. In the Å position, the rain sensor is
more sensitive than in the Ä position, caus-
ing the windscreen wiper to wipe more fre-
quently.
125
Z
Advertisement
