Advertisement
Interior lighting
Overview of interior lighting
Front overhead control panel
p Switches the left-hand front reading
:
lamp on/off
| Switches the automatic interior light-
;
ing control on/off
c Switches the front interior lighting on/
=
off
?
u Switches the rear interior lighting on/
off
p Switches the right-hand front reading
A
lamp on/off
Interior lighting control
General notes
In order to prevent the vehicle's battery from
discharging, the interior lighting functions are
automatically deactivated after some time
except for when the key is in position 2 in the
ignition lock.
The colour, brightness and display lighting for
the ambient lighting are set using the multime-
dia system (see the separate operating instruc-
tions).
Automatic interior lighting control
To switch on/off: press the | button.
X
When the automatic interior lighting control is
switched on, the button is flush with the over-
head control panel.
The interior lighting automatically switches on if
you:
unlock the vehicle
R
open a door
R
remove the key from the ignition lock
R
The interior lighting is activated for a short time
when the key is removed from the ignition lock.
This delayed switch-off can be adjusted via the
multimedia system (see the separate operating
instructions).
Replacing bulbs
Important safety notes
G
WARNING
Bulbs, lamps and plug connectors can
become very hot during use. When replacing a
bulb, you could burn yourself on these com-
ponents. There is a risk of injury.
Allow these components to cool down before
replacing the bulb.
Do not use a bulb that has been dropped or if its
glass tube has been scratched.
The bulb may explode if:
you touch it
R
it is hot
R
you drop it
R
you scratch it
R
Only operate bulbs in enclosed lamps designed
for that purpose. Only fit spare bulbs of the same
type and the specified voltage.
Marks on the glass tube reduce the service life
of the bulbs. Do not touch the glass tube with
your bare hands. If necessary, clean the glass
tube when cold with alcohol or spirit and rub it
off with a lint-free cloth.
Protect bulbs from moisture during operation.
Do not allow bulbs to come into contact with
liquids.
Only replace the bulbs listed (
Have the bulbs that you cannot replace yourself
replaced at a qualified specialist workshop.
If you require assistance replacing bulbs, con-
sult a qualified specialist workshop.
If the new bulb still does not light up, consult a
qualified specialist workshop.
Replacing bulbs
page 124).
Y
Z
123
Advertisement
