Device Specific Information; Installing The Module - National Instruments SCC-TC Series User Manual

Device Specific Information

For general SCC module installation and signal connection information, and
Note
information about the SC-2350 carrier, refer to the SCC Quick Start Guide, available
for download at

Installing the Module

Caution Refer to the Read Me First: Safety and Radio-Frequency Interference document
before removing equipment covers or connecting/disconnecting any signal wires.
SCC-TC0X dual-stage configuration is only available in NI-DAQ 7.1 or later.
Note
SCC-TC Series Thermocouple Input Modules User Guide
.
ni.com/manuals
You can plug the SCC-TC0X into any analog input socket on the SC-2345.
The socket you select determines which E Series DAQ device channels
receive the SCC-TC0X signals.
For single-stage input conditioning, plug the SCC-TC0X into any socket
J(X +1), where X is 0 to 7, and connect the input signals to the module as
described in the Connecting the Input Signals
If you use the SCC-TC0X in a dual-stage configuration, the SCC-TC0X
must be the first-stage module. Plug it into any socket J(X+9) and plug the
second-stage SCC into socket J(X+1), where X is 0 to 7. Connect the input
signals to SCC-TC0X as described in the
section. The SC-2345 connects the output signals of the first-stage SCC to
the inputs of the second-stage SCC. An example of dual-stage conditioning
in an SCC-TC0X followed by an SCC-LP01 lowpass filter module.
Sockets J9 to J16 also are available for digital input/output (DIO)
conditioning or control. Refer to the SC-2345 User Manual for more
information on configuring, connecting, and installing SCC modules
Connecting the Input Signals
4
section.
ni.com