I/O Connector Pin Assignments - National Instruments SCC-TC Series User Manual

Refer to the Declaration of Conformity (DoC) for this product for any additional
Note
regulatory compliance information. To obtain the DoC for this product, visit
ni.com/hardref.nsf
appropriate link in the Certification column.

I/O Connector Pin Assignments

1 Pin 1
© National Instruments Corporation
, search by model number or product line, and click the
Figure 2 shows the I/O connector pins on the bottom of the module.
2 Pin 2 3
Table 1 lists the signal connection corresponding to each pin. AI (X) and
AI (X+8) are the analog input signal channels of the E Series DAQ device.
AI GND is the analog input ground signal and is the reference for AI (X)
and AI (X+8). A GND is the reference for the ±15 V supplies and REF 5V.
AI GND and A GND connect to the SC-2345 at the SCC-PWR connector.
Table 1. SCC Module Pin Signal Connections for SCC-TC0X Modules
Pin Number
1
2
3
4
5
6
4
5
PWB Key 4 Pin 19
Figure 2. SCC Module Bottom View
15 SCC-TC Series Thermocouple Input Modules User Guide
1
2
3
5 Pin 20
Signal
AI (X)
—
—
AI (X+8)
—
AI GND