Table of Contents
Advertisement
Software scaling of measurements is not supported on the Macintosh operating
Note
system. Refer to the
Device Specific Information
Note
For general SCC module installation and signal connection information, and
information about the SC-2350 carrier, refer to the SCC Quick Start Guide, available for
download at
Installing the Module
Caution
Refer to the Read Me First: Safety and Radio-Frequency Interference document
before removing equipment covers or connecting/disconnecting any signal wires.
Note
If you use the SCC-FV01 in a dual-stage configuration, you must use it as the second
stage. Plug the first-stage module into any socket J(X+9) and plug the SCC-FV01 into
socket J(X+1), where X is 0 to 7.
Connecting the Input Signals
Note
The signal names have changed. Refer to
confirm the signal names.
© National Instruments Corporation
SCC-FV01 Module Pin Assignments
.
ni.com/manuals
You can plug the SCC-FV01 into any analog input socket on the SC-2345.
It can function as a single-stage analog input or as the second stage of a
dual-stage analog input configuration. The socket you choose determines
which E Series DAQ device channels receive the SCC-FV01 signals, as
explained in the Connecting the Input Signals section.
For single-stage input conditioning, plug the SCC-FV01 into any socket
J(X+1), where X is 0 to 7, and connect the input-signal wires to the module
as described in the Connecting the Input Signals section.
Sockets J9 to J16 are also available for digital input/output conditioning
or control. Refer to the SC-2345 User Manual for more information on
configuring, connecting, and installing SCC modules.
❑
Each screw terminal is labeled by pin number <1..4>. The SCC-FV01
has two referenced single-ended (RSE) input channels. Pins 1 and 2
form a channel routed to E Series DAQ device channel X+8, and pins
3 and 4 form a second channel routed to E Series DAQ device channel
X. The value of X is determined by the number of the SC-2345 socket
where you plug in the module, J(X+1) or J(X+9). Both input channels
are referenced to AI GND of the E Series DAQ device.
section for more information.
ni.com/info
3
SCC-FV01 Frequency Input Module User Guide
and enter
to
rdtntg
Advertisement
Table of Contents
