Device Specific Information; Installing The Module; Connecting The Input Signals - National Instruments SCC-FT01 User Manual

Note Software scaling of measurements is not supported on the Macintosh operating
system.

Device Specific Information

Note For general SCC module installation and signal connection information, and
information about the SC-2350 carrier, refer to the SCC Quick Start Guide, available
for download at

Installing the Module

Refer to the Read Me First: Safety and Radio-Frequency Interference document
Caution
before removing equipment covers or connecting/disconnecting any signal wires.
If you plug the unmodified SCC-FT01 into any SCC socket other than
Caution
single-stage AI (sockets J1 through J8) or AO (sockets J17 and J18), you can damage
the E Series DAQ device.

Connecting the Input Signals

Note The signal names have changed. Refer to
confirm the signal names.
© National Instruments Corporation
❑
Wire insulation strippers
❑
NI-DAQ (current version) for Windows 2000/NT/XP/Me
If you do not have the current version of NI-DAQ or one of the
documents, you can download them from
NI sales representative.
.
ni.com/manuals
You can plug the SCC-FT01, as shipped, into an AI or AO socket on the
SC-2345. When used as a prototyping module, the SCC-FT01 plugs into
any socket on the SC-2345 except the power socket.
Five 0 Ω resistors on the printed circuit board (PCB) connect a set of default
signals listed on the module label. To modify the SCC-FT01 to perform
custom signal conditioning, refer to the
section.
The screw terminals are labeled by pin number <1..6>. The module label
lists the signal names beside the pin numbers. Pins 2 through 6 accept the
following signals: CH+, CH–, AI GND, AI SENSE, and EXT REF. Pin 1
does not connect to anything. Connect the wires accordingly.
ni.com
Customizing the SCC-FT01
ni.com/info
3 SCC-FT01 Feedthrough Module User Guide
, or contact an
and enter to
rdtntg