Device Specific Information; Installing The Module - National Instruments SCC-DO01 User Manual

Device Specific Information

For general SCC module installation and signal connection information, and
Note
information about the SC-2350 carrier, refer to the SCC Quick Start Guide, available
for download at

Installing the Module

Caution Refer to the Read Me First: Safety and Radio-Frequency Interference document
before removing equipment covers or connecting/disconnecting any signal wires.
Connecting Loads to the SCC-DO01
Note The signal names have changed. Refer to
confirm the signal names.
© National Instruments Corporation
.
ni.com/manuals
Plug the SCC-DO01 into any digital input/output (P0.) socket J(X+9),
where X is 0 to 7, on the SC-2345. When you configure the SC-2345
according to the procedure in the SCC Quick Start Guide, the SC-2345
routes the output signal from digital line P0.(X) on the E Series DAQ
device.
Figure 1 and Figure 2 show two ways to connect a load and an external
voltage supply to the SCC-DO01. These configurations have different
electrical characteristics, as described in the
ni.com/info
Specifications
3 SCC-DO01 Isolated Digital Output Module User Guide
and enter to
rdtntg
section.