Table of Contents
Advertisement
Correct use
1 5
1 6
2
3
3 1
6 | EN
Basic standards and regulations
The screw-on cable tray systems fulfil the requirements of "IEC
61537:2006 – Cable management ‒ Cable tray systems and cable ladder
systems" for the low voltage area.
Applicable documents
– Declaration of conformity, see
https://www.obo.global/service/downloads/declarations-of-conformity/
cable-support-systems/
– Mounting instructions for different support structures:
•
U support systems, see
www.obo.de/out/media/04-150_MA_U_support_systems.pdf
•
I support systems, see
www.obo.de/out/media/04-150_MA_I_support_systems.pdf
•
Universal systems, see
www.obo.de/out/media/04-150_MA_Universal_systems.pdf
•
Trapezoidal systems, see
www.obo.de/out/media/04-150_MA_TP_support_systems.pdf
•
Clamp fastenings, see
www.obo.de/out/media/04-150_MA_Clamp_fastening_systems.pdf
Correct use
The screw-on cable tray systems are used to support and route all kinds
of cables, taking the approved load values into account. Depending on
the corrosion protection used, they can be mounted both indoors and
outdoors.
The cable tray systems are suitable for use at ambient temperatures
of ‒20 °C to +120 °C. At temperatures below ‒20 °C, the material will
become brittle and may not be processed further.
The screw-on cable tray systems are not designed for any other purpose
than the one described here. If the screw-on cable tray systems are used
for another purpose, any liability, warranty or damage claims shall be
rendered null and void.
Safety
General safety information
Observe the following general safety information:
– Only have electrical work carried out by specialist personnel with elec-
trical training.
– Risk of cutting from plate edges. Wear protective gloves.
– Design the screw-on cable tray systems according to the loads to be
expected.
OBO Bettermann
Advertisement
Table of Contents
