Mounting A Reducer Profile/End Closure - OBO Bettermann MKS 310 FS Mounting Instructions

5 5 9
Screw-on cable tray systems

Mounting a reducer profile/end closure

Reducer profiles/end closures are used to reduce tray widths or to close
them off completely. Reducer profiles/end closures have connector per-
foration and are screwed on with FRS M6 truss-head bolts and combina-
tion nuts.
Mounting a reducer profile
1. With unperforated cut cable trays, pre-drill the connector perforation
for connectors, reducer profiles and joint plates.
Fig 65: Bending/adjusting a reducer profile
2. Bend the straps on the reducer profile through 90°.
Fig 66: Mounting straight and angle connector and reducer profile
3. Screw on the RWVL straight and angle connector to the inner side of
the rail.
4. Screw the reducer profile to the inner sides of the rail.
Mounting
53 | EN