Mounting Adjustable Bend Elements - OBO Bettermann MKS 310 FS Mounting Instructions

Mounting
5 5 8

Mounting adjustable bend elements

Adjustable bend elements are used to create height offsets with flexible
bends. Adjustable bend elements are mounted on the cable tray with
a half adjustable connector and FRS M6 truss-head bolts and combin-
ation nuts. Adjustable bend elements are interconnected with SKS
M8x16 hinge screws and locking screws. The angles should be flexible.
Floor end plates are mounted at the ends of the cable trays, in order to
avoid cable damage.
Fig 61: Adjustable bend elements with half adjustable connectors and floor end plates
Note! Always arrange adjustable bend elements with alternating offsets, in
order to avoid a one-sided directional offset.
Fig 62: Mounting floor end plates
1. With unperforated cut cable trays, pre-drill the connector perforation
for adjustable connectors and floor end plates.
2. Screw floor end plates to cable tray bases.
Screw-on cable tray systems 51 | EN