Mounting An Add-On Tee - OBO Bettermann MKS 310 FS Mounting Instructions

5 5 5
Screw-on cable tray systems

Mounting an add-on tee

Add-on tees are mounted to create T branches with small bend radii.
Depending on their width, add-on tees are available with or without WKV
angle connectors.
With connector, 100–300 mm cable tray width
1. With unperforated cut cable trays, pre-drill the connector perforation
for angle connectors and joint plates.
2. Mount the WKV angle connector on the add-on tee.
Fig 45: Notching out a cable tray rail
3. Notch out the cable tray rail with the dimension = W+2x50 mm.
Fig 46: Screwing the add-on tee on a continuous cable tray
4. Insert the straps of the angle connector to the inner side of the
notched-out cable tray rail.
5. Screw the add-on tee to the cable tray rail and cable tray base.
0
x 5
+ 2
W
5 0
Mounting
5 0
B
41 | EN