Table of Contents
Advertisement
3 What to do in case of malfunctions?
Malfunctions are often caused by a trifle. Before
What to do at jst or ingen?
contacting the after-sales service, try to rectify the fault
yourself using the table.
Fix faults yourself
You can often easily remedy technical faults on the
device yourself.
If a dish does not turn out optimally, you will find
many tips and instructions for preparation at the end
of the instructions for use. ~" Tested for you in our
cooking studio." on page 30
Possible
Malfunction
cause
Fuse
Device works
not.
defective.
Power Down
refraction
Power Down
On the display
the time flashes.
refraction.
Device cannot be Child lock is
activated.
be entered
suggested. The
display shows a
key symbol
lit or
'"".
Power Down
The gas burner
does not ignite.
refraction or
moist de-
plug-in card
sen.
- - - - - - - -
:
Warning – Risk of injury!
Improper repairs are dangerous. Never attempt to
repair the device yourself. Repairs should only be
performed by technicians instructed by customer
service. Contact the service department in the event of a
defect in the appliance;
:
Warning – Risk of electric shock!
Improper repairs are dangerous. Repairs and the
replacement of damaged connection cables may only be
carried out by technicians instructed by customer
service. If the device is defective, remove the plug from
the socket or switch off the fuse in the meter box.
Contact customer service.
Error messages on the display
When an error message with "
v.
touch the button
The
error message is then reset. If necessary, reset the time.
If it was a one-time malfunction, you can use the
device as usual. If the error message appears again,
please contact the
Solution / clue
Check the fuse in the
meter box.
Check whether the kitchen light or
other kitchen appliances are
working.
Reset the time.
Deactivate the child lock by
pressing the button with the key
symbol for approx. 4 seconds.
Light the gas burners with
a gas lighter or match.
"
"‹†-„ƒ,
" appears, e.g.
after-sales service, specifying the exact error message and
the E-No. from your device. ~" Customer Service" on page
30
Replacing the interior lamp on the ceiling
If the interior lamp has failed, it must be replaced.
Temperature-resistant 230 V halogen lamps, 25 watts,
can be obtained from the after-sales service or your
specialist retailer.
Hold the halogen lamp with a dry cloth. This extends
the life of the lamp. Only use original lamps.
:
Warning – Risk of electric shock!
When replacing the lamp in the interior, the contacts of
the lamp socket are live. Before proceeding with
replacement, pull out the mains plug from the socket or
switch off the fuse in the meter box.
:
Warning – Risk of burns!
The appliance becomes very hot. Never touch the hot
surfaces in the cooking compartment or heating elements.
Always allow the appliance to cool down. Make sure there
are no children around.
Place a tea towel in the unheated interior to prevent
1.
damage.
Unscrew the glass cover to the left (Fig. !).
2.
Pull out lamp - do not turn (Fig. ").
3.
Insert a new lamp, paying attention to the position
of the pins. Press the lamp firmly.
Screw the glass cover back in. Depending on the type
4.
of device, the glass cover is fitted with a sealing
ring. Replace the sealing ring before screwing in.
Remove the tea towel and switch on the fuse.
5.
What to do in case of malfunctions?
NL
29
Advertisement
Table of Contents
