Transfer - LX Navigation Traffic square User Manual

LX Traffic Square
Device setup

5.2.4 Transfer

The Transfer sub-menu setup page holds all microSD transfer related options. In this setup
page, we will see how to transfer database files, load tasks and FlarmNET files.
LX navigation provides database files on an informative level and can in no
way be held accountable implicitly, or otherwise, for and damage, be it
material, personal or other, that may occur due to the use of this device. It is
the pilot's responsibility to abide to all rules of air safety and to utilize good
airmanship practice. In this sense, information provided by the LX Traffic
Square is of an informative nature only and should be taken with reserve.
No guarantees are made on the accuracy of information found in databases
It is important to note, that some microSD cards of lower quality may cause
issues and not be read by the LX Traffic Square. This is why we strongly
recommend you use the supplied SanDisk Ultra red/grey micro SD card,
supplied with the device, as depicted on the figure below. The microSD card
should be formatted to the FAT32 file system. Cards of up to 32 GB of
memory were successfully tested on the LX Traffic Square.
Pilot must be careful not to exceed the file size of 750 kB, except "FlarmNET" file,
If you have just inserted the microSD card into your LX Traffic Square unit and the
files are not showing up, try leaving the transfer setup page and entering again.
Device manual
WARNING
released by LX navigation.
WARNING
Figure 18. The correct type of microSD
NOTE
where the max file size of 5 MB is allowed.
NOTE
Public
Document name:
Document revision:
LX_SQUM
R1
30