Meridian 405 SLD SEED EXPRESS Operator's Manual page 44

Operator's Manual: 405 SLD Seed Express
14. Use the conveyor FRONT or the conveyor
CRUSHING HAZARD
REAR buttons (switches) to position conveyor
If two people are positioning the conveyor arm;
arm into the desired position. The photos
one at the controls, the other holding the arm,
show the self-filling position.
be extremely careful to prevent a crush hazard.
DO NOT place any part of your body
between stationary and moving parts.
13. When the ball coupling is free of the conveyor
hitch receiver:
- Lift the bottom of the conveyor arm over
the fender
- Hold it off the ground until it is in its final
position.
14. Use the conveyor FRONT or the conveyor
40
REAR buttons
conveyor arm into the desired position.
15. If desired, release the stand lock pin and
rotate the stand downward. Engage the lock
pin when the stand is fully extended.
16. Raise the hopper canvas by pushing the
handlebar forward. The canvas frame will
lock into place when the handle has reached
the end of the rail.
3-24
™
(switches) to position
If two people are positioning the conveyor arm,
one at the controls and the other holding the
Bulk Seed Tender
®
conveyor arm, be extremely careful to prevent
a crush hazard. Do not place any part of your
body between stationary and moving parts.
15. If desired, release the stand lock pin and
rotate the stand downward. Engage the lock
pin when the stand is fully extended.
16. Raise the hopper by pushing the handlebar
forward. The hopper will lock into place when
the handle has reached the end of the rail.
WARNING
Fig 46 - Moving conveyor tube
Fig 47 - Rotate conveyor tube
Fig 48 - Raise hopper canvas
Revised 08.2021
®
To p
the
remo
Alway
a pos
weigh
upward if no
which can r
17. Start the
setting a
Do not
convey