Meridian 405 SLD SEED EXPRESS Operator's Manual page 42

7. Using the remote control unit or the control
Operator's Manual: 405 SLD Seed Express
panel, slightly raise the conveyor from the
transport position.
The indicator mark and the alignment plate
must be aligned for the conveyor arm locking
pin to engage.
- This pin locks the inner and outer tubes of
the conveyor arm together.
- These two tubes must be locked together
before releasing
receiver (ball coupling).
- If tubes are not locked together, the inner
tube will slide down inside the outer tube
and will not come out of the ball catch.
7. Using the remote control unit or the control
7. Using the remote control unit or the control
panel, slightly raise the conveyor from the
panel, slightly raise the conveyor from the
transport position.
transport position.
ELECTROCUTION HAZARD
Keep away from power lines.
• Be aware of your surroundings when raising
or lowering the auger tube.
• Maintain at least 20 feet between the
equipment and any electrical hazard.
• Contact with electricity can result in serious
personal injury or death.
6. Swing the conveyor.
7. Align the triangular indicator on the conveyor
pivot plate with the alignment plate on the
frame, as shown.
8. Using the remote control unit or the control
8. To lock the conveyor arm tubes together, pull
panel, rotate conveyor to align the triangular
the handle of the lock pin outward slightly
indicator on the conveyor pivot plate with the
and rotate it 90° counterclockwise.
alignment plate on the frame, as shown.
3-22
8. Using the remote control unit or the control
8. Using the remote control unit or the control
panel, rotate conveyor to align the triangular
Bulk Seed Tender
™
the conveyor hitch
MMG-00322b
MMG-00322b
MMG-00322b
8. Using the remote control unit or the control
panel, rotate conveyor to align the triangular
indicator on the conveyor pivot plate with the
®
alignment plate on the frame, as shown.
Fig 38 - Remote control handset
NOTICE
Fig 39 - Control panel switch
The indicator mark and the alignment plate must be
aligned for the conveyor arm locking pin to engage.
This pin locks the inner and outer tubes of the
conveyor arm together. These two tubes must be
locked together before releasing the conveyor hitch
receiver (ball coupling). If the tubes are not locked
together, the inner tube will slide down inside the
outer tube and will not come out of the ball catch.
9. To lock the conveyor arm tubes together, pull
the handle of the lock pin outward slightly and
rotate it 90° counterclockwise.
Fig 40 - Align triangle indicator
NOTICE
NOTICE
The indicator mark and the alignment plate must be
The indicator mark and the alignment plate must be
aligned for the conveyor arm locking pin to engage.
aligned for the conveyor arm locking pin to engage.
1
This pin locks the inner and outer tubes of the
This pin locks the inner and outer tubes of the
conveyor arm together. These two tubes must be
conveyor arm together. These two tubes must be
locked together before releasing the conveyor hitch
locked together before releasing the conveyor hitch
receiver (ball coupling). If the tubes are not locked
receiver (ball coupling). If the tubes are not locked
together, the inner tube will slide down inside the
together, the inner tube will slide down inside the
outer tube and will not come out of the ball catch.
outer tube and will not come out of the ball catch.
Fig 41 - Lock conveyor tubes together
9. To lock the conveyor arm tubes together, pull
9. To lock the conveyor arm tubes together, pull
the handle of the lock pin outward slightly and
the handle of the lock pin outward slightly and
rotate it 90° counterclockwise.
rotate it 90° counterclockwise.
MMG-00324
MMG-00324
MMG-00324
2
MMG-00328
Revised 08.2021
rotate it
®
39