Positioning The Casters; Installing The Lock Bracket; Installing The Snowthrower - Toro GrandStand Multi Force 78598 Operator's Manual

2
Removing the Mower Deck
No Parts Required
Procedure
Refer to the Removing the Deck procedure in the
Operator's Manual for your machine. Retain the
fasteners securing the strut bracket to the machine.
3

Positioning the Casters

No Parts Required
Procedure
Remove the nut and bolt from each caster, move the
caster to the middle position, and install the nut and
bolt (Figure 3). Torque to 91 to 113 N∙m (67 to 83 ft-lb).
1. Nut and bolt
Figure 3
2. Middle position
4

Installing the Lock Bracket

Parts needed for this procedure:
1 Lock bracket assembly
Procedure
1. Remove the 4 carriage bolts (3/8 x 2-1/2 inches),
4 nuts (3/8 inch), and the existing lock bracket
(Figure 4).
1. Carriage bolt (3/8 x 2-1/2
inches)
2. Nut
2. Use the fasteners that you just removed to install
the snowthrower lock bracket
to 37 to 45 N∙m (27 to 33 ft-lb).
g210119
1. Carriage bolt (3/8 x 2-1/2
inches)
2. Nut
6
Figure 4
3. Lock bracket
(Figure 5). Torque
Figure 5
3. Snowthrower lock bracket
g210329
g210328