Preventing Freeze-Up After Use; Operating Tips - Toro GrandStand Multi Force 78598 Operator's Manual

Figure 26
1. Tie-down loops
Unloading the Machine
1. Lower the ramp.
2. Unload the machine from the trailer with the
heavy end up the ramp
•
If the attachment is installed, unload the
machine with the front up the ramp.
•
If the attachment is not installed, unload the
machine with the rear up the ramp.
Figure 27
Machines without the attachment installed
1. Machine with
attachment—unload the
machine with the front up
the ramp.
g032703
g309802
(Figure 27).
g309767
2. Machine without
attachment—unload the
machine with the rear up
the ramp.
Preventing Freeze-up after
Use
•
In snowy and cold conditions, some controls and
moving parts may freeze. Do not use excessive
force when trying to operate frozen controls.
If you have difficulty operating any control or part,
start the engine and let it run for a few minutes.
Thaw frozen parts before operating the machine.
•
After using the machine, let the engine run for a
few minutes to prevent moving parts from freezing.
Shut off the engine, wait for all moving parts
to stop, and remove all ice and snow from the
machine.

Operating Tips

•
Always set the throttle to the F
throwing snow.
•
Remove snow as soon as possible after it falls.
This produces the best snow removal results.
•
Do not overload the snowthrower by clearing snow
at too fast a rate.
•
If the engine slows down or the front of the
snowthrower rides up, reduce the forward speed.
•
Discharge snow downwind whenever possible
and overlap each pass to ensure complete snow
removal. If wheels slip, reduce the forward speed.
•
Run the snowthrower for a few minutes after
clearing snow so that moving parts do not freeze.
15
position when
AST