Toro GrandStand Multi Force 78598 Operator's Manual page 8

4. Loosely install the chute-cable bracket on the
frame near lift-arm assembly.
Figure 9
1. Carriage bolt (5/16 x 4
inches)
2. Chute-cable bracket
5. Remove the shoulder bolt, washer, and nut
securing the linkage to the lift-arm assembly.
Discard the washer.
Figure 10
1. Nut
2. Washer
g329113
3. Nut (5/16 inch)
4. Lift-arm assembly
g330428
3. Shoulder bolt
6. Route the chute cable between the chute and
the chute post.
7. Use the shoulder bolt and nut to install the chute
cable to the lift-arm assembly. Torque the bolt
98 to 119 N∙m (72 to 88 ft-lb).
Note:
When you remove the snowthrower from
the machine, remove the fasteners securing the
cable to the cable plate shown in
not remove the cable plate from the linkage and
lift-arm assembly.
1. Nut
2. Chute cable
3. Remove these fasteners
when removing the
snowthrower.
8
Figure 11
Figure
Figure 12
4. Cable plate
5. Shoulder bolt
g334147
13. Do
g329114