Setup; Preparing The Machine; Removing The Mower Deck - Toro GrandStand Multi Force 78598 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
Install the following (sold separately on your machine
before you install the snowthrower:
•
Float Kit (optional)
•
High Flow Hydraulic Kit (required)
•
Low Flow Hydraulic Kit (required)
•
Pneumatic casters (required)
•
Snow Tires (recommended)
•
Wheel Weight Kit (required)
A Lift Cylinder Lock Kit (Part No. 137-4106) is
available to secure the A-frame when you raise it for
setup or maintenance; contact your Authorized Toro
Dealer.
Reverse the procedures to remove the snowthrower
after installation.
Description
No parts required
No parts required
No parts required
Lock bracket assembly
Snowthrower attachment
Stop block
Chute-cable bracket
Carriage bolt (3/8 x 1-1/2 inches)
Carriage bolt (5/16 x 4 inches)
Nut (3/8 inch)
Nut (5/16 inch)
Washer
High Flow Case Drain Kit
No parts required
No parts required
Qty.
–
Prepare the machine.
–
Remove the mower deck.
–
Position the casters.
1 Install the lock bracket.
1
2
1
2
Install the snowthrower.
1
2
1
2
1 Install the High Flow Case Drain Kit
–
Connect the hoses.
–
Set the snowthrower height.
1

Preparing the Machine

No Parts Required
Procedure
1. Park the machine on a level surface.
2. Disengage the PTO, engage the parking brake,
and move the motion-control levers outward to
the N -L
EUTRAL
3. Raise the A-frame and support it using blocks
or a cylinder lock.
4. Shut off the engine and remove the key.
5
Use
position.
OCK