Controls; Operation; Operating The Snowthrower - Toro GrandStand Multi Force 78598 Operator's Manual

Controls

Use the switches from the Low Flow Hydraulic Kit
(Figure 21) and the height-of-cut lever to operate the
snowthrower.
Low Flow Hydraulic Kit Switches
•
Move the left switch up or down to raise or lower
the snowthrower.
•
Move the right switch left or right to angle the
discharge chute.
Figure 21
1. Raise or lower the
snowthrower
Power-Takeoff Switch (PTO)
Use the power-takeoff switch (PTO) to start and stop
the attachment.
Height-of-Cut Lever
Use the height-of-cut lever to raise and lower the
snowthrower deflector.
g037041
2. Angle the discharge chute
left or right.

Operation

Operating the Snowthrower

Important:
Raise the snowthrower when
transporting it.
1. Start the machine.
2. Move the throttle lever midway between the
F and S
AST LOW
Note:
In cold conditions, the traction unit engine
may need time to warm up prior to engaging the
attachment.
3. Engage the PTO switch to start the snowthrower
auger.
4. Move the throttle lever to the F
before clearing snow.
5. Disengage the PTO switch or release the
motion-control levers to stop the snowthrower
auger.
Note:
The auger should spin counterclockwise when
viewed from the left side from the operating position
(Figure 22). If the auger spins in the wrong direction,
switch the couplers on the hydraulic hoses connected
to the High Flow Kit.
12
positions.
position
AST
Figure 22
g330393