Clearing A Clogged Snowthrower; Adjusting The Drift Breakers; Transporting The Machine; Figure 23 - Toro GrandStand Multi Force 78598 Operator's Manual

Clearing a Clogged
Snowthrower
WARNING
If the auger/impeller is running but there is no
snow coming out of the discharge chute, the
discharge chute may be clogged.
Never use your hands to clear a clogged
discharge chute. This could result in personal
injury.
Note:
If an object is lodged in the auger, reverse the
hydraulic flow. If this does not dislodge the object,
continue as follows.
1. Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Disconnect the hydraulic hoses.
4. Use a stick to clear the snowthrower.
5. Connect the hydraulic hoses before resuming
operation.

Adjusting the Drift Breakers

1. Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Loosen the 2 nuts on each drift breaker and
adjust the breaker as necessary
4. Tighten the nuts.
1. Nut

Transporting the Machine

Use a heavy-duty trailer or truck to transport the
machine. Use a full-width ramp. Ensure that the trailer
or truck has all the necessary brakes, lighting, and
marking as required by law. Please carefully read all
the safety instructions. Knowing this information could
help you or bystanders avoid injury. Refer to your
local ordinances for trailer and tie-down requirements.
WARNING
Driving on the street or roadway without
turn signals, lights, reflective markings, or a
slow-moving-vehicle emblem is dangerous
and can lead to accidents, causing personal
injury.
Do not drive the machine on a public street
or roadway.
13
(Figure

Figure 23

2. Drift breaker
23).
g309342