Replacing The Trip Edges; Checking The Auger-Gearbox-Oil Level; Stop Bolt; Jam Nut - Toro GrandStand Multi Force 78598 Operator's Manual

A. Support the A-frame using blocks or a
cylinder lock.
B. Loosen the jam nut.

1. Stop bolt

C. Adjust the stop bolt until it contacts the
A-frame.
Note:
This prevents the hydraulics from
applying force on the skids and reduces
wear.

Replacing the Trip Edges

Service Interval: Every 50 hours—Check the trip
edges.
Replace the trip edges when they are worn.
Note:
Operating conditions affects trip-edge wear.
Operating the snowthrower on dry pavement will
cause the trip edges to wear faster than operating it
on wet snow.
1. Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the bolts and retainer plate.
Figure 29

2. Jam nut

1. Bolt (4)
2. Retainer plate
4. Remove the trip edge and install a new one
using the retainer plate and fasteners.
Checking the
Auger-Gearbox-Oil Level
g330392
Service Interval: Yearly
1. Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Clean the area around the pipe plug and remove
the pipe plug from the gearbox.
Note:
If needed, use pliers to assist in removing
the pipe plug.
4. Check the oil level using a suitable measuring
device, such as a clean cable tie. The oil should
be approximately 3.8 cm (1.5 inches) below the
filler opening
17
Figure 30
3. Trip Edge
Figure 31
g309426
g334133