Digigram IQOYA CALL Series User Manual page 4

INFORMATION FOR THE USER
This equipment has been tested and found to comply with the limits for a CLASS B digital device, pursuant to Part 15 of the
FCC Rules and with the following European and international Standards for:
User safety:
European Directive 2006/95/EC "Low Voltage
Directive
Europe: EN60950 1 (2006)
International: IEC 60950 1 (2005)
RoHS:
European directive 2002/95/EC aka "RoHS"
In order to guarantee compliance with the above standards in an installation, the following must be done:
∙ the provided cables must not be modified.
∙ additional cables used must have their respective shield connected to each extremity.
The limits specified in the standards are designed to provide reasonable protection against harmful interference in an
industrial installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
* reorient or relocate the receiving antenna.
* increase the separation between the equipment and the receiver.
* connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
* consult the dealer or an experienced audio/television technician for help.
Note ​ : Connecting this device to peripheral devices that do not comply with CLASS A requirements or using an unshielded
peripheral data cable could also result in harmful interference to radio or television reception. The user is cautioned that any
changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate this equipment. To ensure that the use of this product does not contribute to interference, it is necessary to use
shielded I/O cables.
Copyright ​ ©​ 2015 Digigram. All rights reserved.
No portion of this manual may be reproduced without prior written consent from Digigram. The copyright protection claimed here includes
photocopying, translation and/or reformatting of the information contained in this manual.
While every effort has been made to ensure accuracy, Digigram is not responsible for errors, omissions or typos, and reserves the right to
make improvements or changes in the products and programs described without notice.
Digigram and the Digigram logo, visiblu and the visiblu logo, and IQOYA are registered trademarks or trademarks of Digigram S.A.. HE­AAC
and AAC­(E)LD are registered trademarks or trademarks of Fraunhofer IIS. All other trademarks are property of their respective holders.
I QOYA *CALL - IQOYA *CALL/LE
​
EMC:
United States: FCC rules Part 15 Class B
International: CISPR22 (2005) Class B + A1/2005 + A2/2006
European Directive: EMC 2004/108/EC
Europe: Disturbance Emissions: EN55022 (2006) +A1/2007
Requirements for Information Technology Equipment (ITE)
Immunity: EN55024(1998+A1/2001+A2/2003) (ITE)
Harmonics: EN61000­3­2 (2006)
Note: to comply with standard EN55024, use shielded
network cables!
User Manual v0.99
4 / 77