Digigram IQOYA CALL Series User Manual page 28

Note that IQOYA *CALL and IQOYA *CALL/LE allows configuring two VLANs per IP port, typically a VLAN for IP
audio data, and a VLAN for control. This complies with VLAN tagging IEEE 802.1q and 802.1p.
● Click on the 'Configure' button to be able to modify the parameters.
● If you want to disable the IP port, select "Stopped" in the "Status" field. Status "running" means the IP port
is enabled.
WARNING : Make sure not to disable both interfaces Eth0 and Eth1.
● Select the appropriate mode for the IP interface speed and transmission mode (Auto­negotiation, 10/100
Mbits/s, half/full duplex).
● Enable or disable the DHCP mode, according to you network configuration. If DHCP mode is Off, enter a
valid IP address, the subnet mask, and if necessary the gateway and DNS IP addresses.
● Confirm the settings by clicking on 'Apply'.
● Type the new IP address into the address bar of the browser to access the IQOYA *CALL or IQOYA
*CALL/LE again.
● Do the same for the "Eth1" network interface (IP Backup/Control) if required. By default Eth1 is disabled.
WARNING : Make sure that Eth0 and Eth1 have IP addresses belonging to different subnets.
I QOYA *CALL - IQOYA *CALL/LE
​
User Manual v0.99
28 / 77