Candy CATL 7080 WKI Instruction Manual page 18

Insufficient E4
water
injection
Water level E6
sensor
abnormal
Water intake E7
or automatic
drainage
Memory E9
chip failure
Foam EA
anomaly
Motor or F1-F3,F7
frequency
transformer
failure
F5-F6
Unable to No display
start or not
boot
Note: After you check the items and remove the trouble, restart the washing
machine. If there is still an abnormality, please unplug the power plug and
call our customer service phone as soon as possible.
The faucet is not on, the water
is stopped or the water
pressure is low. After 30
minutes, the water level is less
than the set water level.
Water level sensor failure,
open circuit or short circuit,
then automatically alarm.
Computer board, inlet valve, or
water level sensor is abnormal.
Can't read and write
Excessive foam in dehydration
Frequency transformer
Failure.
Over voltage, overload or
inverter failure
Computer board failure
18
Open the tap or wait until the water
pressure is normal before use.
Open the cover, close the cover,
and re-enter the water inlet
process.
Please have professional
maintenance personnel overhaul.
Turn off the power after the water is
finished. Please have professional
service personnel repair it.
Turn off a machine
Open the cover and close it.
Restart the machine after shutdown
for 10 seconds. If the fault has not
been solved, please repair it by
professional personnel.
Reduce the washing weight and
restart the machine. If the fault is
still not solved, please ask
professional personnel for
maintenance.
Please have professional
maintenance personnel overhaul.