Candy CATL 7080 WKI Instruction Manual page 14

After turning on the power, if there is water in the washing tub, the washing machine cannot
enter the blur function. The default is the 5 water level of the Normal program.
After turning on the power, press the "Start/Pause" button directly and the default intelligent
program can automatically judge the water level.
4) Press the "Start/Pause" button to boot the system.
After the system starts, if you need to change the setting program, you can press the "
Start/Pause" button to pause the system operation, then press other buttons to set, and finally
press the "Start/Pause" button, the system will run according to the newly set program.
5) Close the top cover and the washing machine enters the running state.
Do not open the top cover during the operation of the washing machine, especially during

the dehydration process to avoid accidents.
6) When the laundry is over, it will automatically beep and power off.
2. Self programming operation method
1) Press the ON/OFF button to turn on the washing machine and press the "Program" button
to select the appropriate program.
2) Press the "Wash", "Rinse" and "Spin", "Water level" and "Preset" function buttons to set the
appropriate washing time, rinsing times, spinning time, appropriate water level and appropriate
appointment time, and whether there is "water retention" function.
3) Press the "Start/Pause" button to boot the system.
4) Close the top cover and the washing machine enters the running state.
3. "Water retention" operation method
1) After turning on the power, the default setting of the machine is no water retention function,
and the "water retention" indicator is off. If you want to start this function, you can press the
"Rinse" button from the program operation to the last drainage to make the "water retention" light
on. If it is not necessary, you can press the "Rinse" button again to turn off the "water retention"
light.
2) After selecting the water retaining function, when the program runs to the last drainage, the
"water retention" light flashes, and an alarm is given every five minutes to prompt the user to
contain water. When the user is ready to receive the water container, press the "Rinse" button,
and the "water retention" light is off to start drainage. In this drainage process, press the "Rinse"
button to switch between drainage and stop drainage.
3) If the user does not press the "Rinse" button when draining the water for the last time, the "
water retention" light will be flashing all the time, and an alarm will be given every five minutes to
14