Powering Up The Unit - IMD MD.2 User Manual

c. Remove the foam packaging material from behind the MD.2 door. This piece of packaging
foam protects the precise moving parts in the unit during shipping. Failure to remove this
packaging foam will cause unit to malfunction.
d. Connect the MD.2 to nearest telephone line outlet with the phone cable(s) provided. If a
telephone must be disconnected from the wall jack, the telephone may be re-plugged into the
convenient extension jack in the back of the MD.2. Refer to Figure 3 for location of the
telephone connectors on the back of the MD.2.
e. Make sure the MD.2 power switch is in the off position (refer to Figure 3). Plug the small end
of the AC power adapter into the back of the MD.2. Plug the large end of the AC adapter into
a wall outlet. Note: Make sure that the wall outlet is not a switched outlet (i.e. controlled by
a wall switch somewhere in the room).
f. Please refer to page 45 at the back of this manual for information regarding the rechargeable
battery.
g. Save packing box in the event of repair.
FIGURE 3 CONNECTOR PANEL LAYOUT
Telephone Connector

Powering Up the Unit

When the MD.2 has been readied for use as outlined in the previous section, it is ready to put into
service. Turn the unit on by pushing the slide switch at rear of unit to the On position. The
display will first read:
S e l f T e s t
P l e a s e W a i t
This self-test operation takes one to two minutes. Once the unit has successfully passed its self-
test and has aligned its medication cup cylinders, the screen will read:
R e a d y
S y s t e m
Additionally, the MD.2 voice will say "System OK, Ready for setup". A default time setting will
be flashing in the lower right corner.
MD.2 Users Manual
On
Off
On/Off Switch
U n d e r w a y
f o r S e t u p
O K 1 2 : 0 0 A
Power Jack
13