Carrier Operation; Carrier Controls; Pre-Start Checklist - MacDon 1000 Operator's & Parts Manual

WARNING: When transporting on public roadways use amber flashers day or
night. Do not tow over 20 mph (32 km/h) when loaded.

CARRIER CONTROLS

The control handle (attached to the top of the
tractor's hydraulic lever) is fitted with one (1)
button type switch. Depressing the button,
while operating the hydraulic lever, results in
the tilting or raising of the bale deck.
The control grip is connected to the solenoid
valve mounted on the tilt cylinder of the bale
carrier.

PRE-START CHECKLIST

Check the following areas daily before operating the bale carrier. This should ensure that the bale
carrier functions properly and avoid breakdowns and accidents.
1. Check that all component and assemblies are complete and that all shields are in place.
2. Check for missing fasteners and replace if necessary (it is normally not necessary to
retighten fasteners on a daily basis).
3. Tighten loose wheel bolts, especially if tire has been removed recently (wheel bolts do not
normally require daily inspection).
4. Clean bale carrier of any foreign material that may have accumulated from previous runs.
5. Lubricate all points requiring daily lubrication.
6. Check and maintain proper tire pressure.
7. Check CABLE tension and adjust if necessary.
8. Ensure chain is disengaged from SAFETY LOCK BRACKET before lowering BALE LIFT
ARM.

CARRIER OPERATION

22
CONTROL HANDLE