MacDon 1000 Operator's & Parts Manual page 33

3.
Insert the CABLE and (coming from the
TOP of the DRUM underneath the bottom
of the 4" pulley on the PUSHER) pull
CABLE around to the top of the pulley,
then insert CABLE at top of pulley on
CABLE TIGHTENER BRACKET and pull
it around to the bottom of this pulley.
Form loose end of CABLE into a U-shape,
insert through narrow end of holder on
PUSHER and secure with WEDGE.
4. Position the rear pulley holder to the front
of its slot. This is achieved by unscrewing
both the rear facing 5/8" bolts on the
pulley mount.
5. Pull CABLE tight. Check that rear
PULLEY HOLDER WITH PULLEY is in its
maximum forward position and wrap long
end of CABLE around this pulley.
6. Remove CABLE INSTALLATION TOOL
from its storage position on the LEFT
HITCH BEAM and place its bracket on
front of CABLE TIGHTENER BRACKET.
Pass CABLE through holder on the other
end of the TOOL and secure with
WEDGE. Tighten CABLE by screwing in
bolt on end of TOOL.
CABLE INSTALLATION (PUSHER FRAME)
CABLE INSTALLATION TOOL STORAGE
ATTACH TOOL HERE
INSTALL CABLE WITH CABLE
INSTALLATION TOOL
33