Yamaha VMAX 2009 Service Manual page 123

1. Clutch hose
2. Brake hose (hydraulic unit to left front brake
caliper)
3. Brake hose (front brake master cylinder to
hydraulic unit)
4. Brake hose (left front brake caliper to right front
brake caliper)
5. Front wheel sensor lead
6. Front right turn signal light lead
7. Front left turn signal light lead
A. Install the rubber damper so that the slits in the
damper are toward the front frame.
– –
B. 45 51 mm (1.77 2.01 in)
C. To hydraulic unit
– –
D. 0 3 mm (0 0.12 in)
E. Fasten the clutch hose with the holder on the oil
pipe 1.
F. Insert the projection on the holder into the hole in
the clutch hose holder bracket, and then fasten the
clutch hose with the holder. Face the catch of the
holder inward.
– –
G. 60 80 mm (2.36 3.15 in)
– –
H. 10 30 mm (0.39 1.18 in)
I. Fasten the front right turn signal light lead, front left
turn signal light lead, and grommet on the brake
hose (front brake master cylinder to hydraulic unit)
with the holder.
J. Face the catch of the holder rearward.
K. Fasten the front left turn signal light lead to the
brake hose and front left turn signal light lead guide
with plastic locking ties. Align the plastic locking
ties with the cutouts in the guide. Cut off the
excess end of each plastic locking tie to 2
–
(0.08 0.20 in). The end of each plastic locking tie
may be pointing in any direction.
– –
L. 7 13 mm (0.28 0.51 in)
M. Route the front wheel sensor lead between the
brake hose guide and the front frame.
N. Fasten the front left turn signal light lead with a
plastic locking tie. Position the plastic locking tie
under the bent portion of the brake hose and front
left turn signal light lead guide.
O. Point the end of the plastic locking tie to the left,
and then cut off the excess end of the tie to 2
–
mm (0.08 0.20 in).
–
5 mm
–
5
2-70
CABLE ROUTING