Yamaha VMAX 2009 Service Manual page 184

d. In the order pinch bolt "3" → pinch bolt "4" →
pinch bolt "3", tighten each bolt to 21 Nm (2.1
m·kgf, 15 ft·lbf) without performing temporary
tightening.
1 2
L LLL L LLL L L LLL L
6. Measure:
TIP
Measure the distance "a" only if the wheel bear-
ings, wheel sensor rotor, or both were replaced.
• Distance "a"
(between the wheel sensor rotor "1" and
wheel sensor housing "2")
Out of specification → Reinstall the bearing
or replace the wheel sensor rotor.
Distance "a" (between the wheel
sensor rotor and wheel sensor
housing)
29.2–29.5 mm (1.15–1.16 in)
2
1
7. Install:
• Front brake calipers
• Front wheel sensor
• Front wheel sensor lead holder
Front brake caliper bolt
35 Nm (3.5 m·kgf, 25 ft·lbf)
Front wheel sensor bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
Front wheel sensor lead holder
bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
3 4
L LLL L L LLL L L LLL L
a
TIP
• When installing the front wheel sensor, check
the wheel sensor lead for twists and the sensor
electrode for foreign materials.
• Install the front wheel sensor lead holder with
the "UP" mark facing up and to the inside.
ECA2S31014
NOTICE
• Make sure there are no foreign materials in
the wheel hub. Foreign materials cause
damage to the inner sensor rotor and wheel
sensor.
• To route the front wheel sensor lead, refer
to "CABLE ROUTING" on page 2-47.
LLL
EWA13500
WARNING
Make sure the brake hose is routed properly.
8. Check:
• Front wheel sensor installation
Check if the wheel sensor housing is installed
properly.
4-19
FRONT WHEEL