Warranty; Limited Warranty; Pre-Installation; Planning Installation - Everbilt EB-PUMP-T Use And Care Manual

Warranty

LIMITED WARRANTY

All pumps are warranted to be free of defects in workmanship and materials for a period of 12 months from the date of the original
consumer purchase. The original sales receipt is required to determine eligibility for this warranty. The manufacturer will credit, repair or
replace, at its option, any pump if deemed defective within this time period. All products returned to the manufacturer must include a return
authorization issued by the manufacturer. No service requests will be accepted if the pump is received more than 30 days following the
warranty term. The returned product should be suitably packaged and shipped prepaid from the point of shipment to the point designated
in the manufacturer's return authorization which may include the original retail outlet. This warranty is a limited warranty and shall be in
particular purpose. There are no other warranties that extend beyond the description of the face hereof. The liability of the manufacturer
arising out of its supply of said products, or their use, shall not in any case exceed the cost of correcting defects in the products as set forth
above. The manufacturer shall not be liable for any costs or damage incurred by its customers in the removal or replacement of defective
consequential, or incidental damages. Some states do not allow limitations on the length on an implied warranty or do not allow the
exclusions or limitations of incidental or consequential damages. Therefore the mentioned exclusions or limitations may not apply. The legal
rights of this limited warranty may vary from state to state.
Contact the Customer Service Team at 1-877-528-3878 or visit www.HOMEDEPOT.com.

Pre-Installation

PLANNING INSTALLATION

Before beginning assembly of the product, make sure all parts are present. Compare parts with package contents list and hardware
contents list. If any part is missing or damaged, do not attempt to assemble the product.
This pump is designed to automatically remove the condensate water that collects from appliances such as air conditioners, high
ers. The pump has a built-in tank that collects the water from the appliance. When the water collected reaches
cient level inside the pump tank, the pump switches on and pumps the water to a remote location for disposal. When the tank is
ciently empty the pump automatically switches off. The pump is capable of lifting water up to 20 ft. and is equipped with a check valve
power available, motor running and high water (alarm) conditions. The pump is also equipped with a switch that activates when the water
occurs.

UNPACKING

Carefully open the carton to avoid damage to the pump. Do not use a knife or other sharp object that may scratch the pump's cover. After
opening the carton, look for damage. If damage is found, please return the unit to the point of purchase for a replacement.

TOOLS REQUIRED

Safety goggles
Phillips
screwdriver
Wall anchors (2)
(For wall mount
only.)
Level
1/2 in. hose
clamp
3
l P a e e s o c t n
tness for a
Screws (2)
(For wall or air
handler mount
only)
Drain tubing
(Only needed
when
connecting a
condensate
pump to a
er. )
H O
c a 1 t 8 - 77-528-3878 f r o u f t r
ts, indirect,
ciency
ter condition
M D E P E T O C . O M
e h a r s s s i a t c n . e