Page 1
THANK YOU We appreciate the trust and confidence you have placed in Everbilt through the purchase of this submersible sewage pump. We strive to continually create quality products designed to enhance your home. Visit us online to see our full line of products available for your home improvement needs.
Safety Information (continued) CAUTION: Call an electrician when in doubt. The pump WARNING: If the pump is damaged, have it inspected by should be connected to a separate 20 A circuit breaker or an authorized service center. 20 A fuse block. Plugging into existing outlets may cause low voltage at the motor.
Warranty (continued) h) this warranty will not apply to normal deterioration of the exterior finish, such as, but not limited to, scratches, dents, paint chips, or to any corrosion or discoloring by heat, abrasive and chemical cleaners; and i) this warranty will not apply to component parts sold by and identified as the product of another company, which shall be covered under the product manufacturer’s warranty, if any.
Pre-Installation (continued) PERFORMANCE CHART GPH of Water @ Total Feet of Lift Max. Lift Volt Amps 0 ft. 5 ft. 10 ft. 15 ft. 20 ft. 25 ft. 26 ft. 1000 026 319 6/10 115V 9910 8900 7500 5800 4000 MATERIALS REQUIRED (NOT INCLUDED) Before using this pump, ensure you have the following items: 2 in.
Installation Connecting a discharge pipe to the Placing the pump in a basin pump □ □ Wrap the threads of the 2 in. discharge pipe (1) with thread Place the pump on a hard surface inside a sewage basin. sealant tape. □...
Operation Connecting power Operating the pump □ □ Plug the pump power cord plug into the piggyback switch When the float switch (1) moves up over the top of the plug outlet. pump, the pump begins to operate. When the water lowers to a certain level, the float switch (1) will turn the pump off.
Care and Cleaning To clear a pump that is clogged with debris: □ Unplug the pump to disconnect the electrical power. □ Unscrew the four screws (4) on the pump body and remove the volute (1) and O-ring (2). □ Remove debris from around the impeller (3).
Troubleshooting WARNING: Before servicing a pump, always shut off the CAUTION: Call an electrician when in doubt. The pump main power breaker and then unplug the pump. Under should be connected to a separate 20 A circuit breaker or flooded conditions, make sure you are not standing in water 20 A fuse block.
Service Parts Description Part Number Quantity Volute HDESE6001-1 Float switch HDESE6002...
Page 11
Questions, problems, missing parts? Before returning to the store, call Everbilt Customer Service 8 a.m. – 7 p.m., EST, Monday-Friday, 9 a.m. – 6 p.m., EST, Saturday 1-844-883-1872 HOMEDEPOT.COM Retain this manual for future use.