Download Print this page
Everbilt ZE00802A Quick Start Manual

Everbilt ZE00802A Quick Start Manual

Non-submersible transfer pump
Hide thumbs Also See for ZE00802A:

Advertisement

Quick Links

70*17mm
logo
60*35mm
WARNING/ADVERTENCIA
You MUST use this suction strainer when using this pump. Push
the clear hose into the rubber connection on the strainer. Failure
to use this strainer WILL VOID WARRANTY!
Place the strainer in at least 1/2 in. of water at the lowest point
to be pumped.
Debe utilizar este filtro de succión cuando se utiliza esta bomba.
Empuje la manguera transparente en la conexión de goma en el
colador. Si no se utiliza este filtro ANULARÁ LA GARANTÍA!
Coloque el colador en al menos un medio en. De agua en el
punto más bajo a bombear.
warning
210*60mm
WARNING
• Connect the pump DIRECTLY to a properly grounded, 115V GFCI outlet and
never use an extension cord to power this pump
• Pull plug before servicing this pump
• This pump has not been tested or approved for use in swimming pools or in
salt-water marine areas
• Do not pump flammable or explosive liquids, pump water only with this pump
• To reduce risk of electrical shock, fully read, follow and save the operating and
installation instructions before attempting to install or operate this pump
• Do not run this pump dry
• NOTICE: Do not handle pump with wet hands or when standing on a wet surface,
or in water
• Pump will be EXTREMELY LOUD when water is no longer pumped.
UNPLUG IMMEDIATELY
• This pump is not waterproofed. Do not submerge in any liquid
cord tag
Pump must be unplugged
manguera transparente en ENTRADA.
La bomba debe ser desconectado
SKU:1000 000 000 MODEL:ZE00802A
MADE IN CHINA
108*35mm
SKU 1001 093 976
Model ZE00802A
Non-Submersible Transfer Pump
No sumergible Bomba de transferencia
115V 60Hz 1/10HP 1.8Amps
THERMALLY PROTECTED
PROTECCIÓN TÉRMICA
Serial No./Serial No.: 000000
Date Code/Código de Fecha: 1439
name plate
42*42mm
You MUST
attach supplied clear
hose onto INLET.
when water is gone.
Debe adjuntar suministrado
cuando el agua se ha ido.
pump lable
ADVERTENCIA
• Conecte la bomba DIRECTAMENTE a una toma de tierra, nunca utilice un cable de
extensión para proporcionar alimentación a la bomba
• Desconecte la bomba antes de cualquier clase de mantenimiento
• Esta bomba no se ha puesto a prueba y no ha sido aprobada para uso en piscinas
o en áreas de agua salada
• No bombee líquidos inflamables o explosivos, bombee solamente agua con esta
bomba
• Para reducir el riesgo de descarga eléctrica, lea totalmente, siga y guarde las
instrucciones de uso e instalación antes de intentar instalar o utilizar la bomba
• No haga funcionar esta bomba en seco
• AVISO: No maneje la bomba con las manos mojadas o estando en agua o en la
superficie mojada
• La bomba resultar demasiado alto cuando el agua ya no se bombea.
Desenchufe inmediatamente
• Esta bomba no está impermeabilizado. No lo sumerja en ningún líquido.
WARNING/ADVERTENCIA
• This pump is used for clean water only.
• This pump is not waterproofed. Do not submerge in any liquid.
• To increase impeller life, wet the impeller or fill out the inlet
with water before connecting garden hoses.
• Esta bomba se utiliza sólo agua limpia.
• Esta bomba no está impermeabilizado. No lo sumerja
en ningún líquido.
• Para aumentar la vida del impulsor, mojar el impulsor o
llene la entrada con agua antes de conectar las
mangueras de jardín.
47mm*22mm
WARNING/ADVERTENCIA
This base will help prevent the pump from
tipping over. DO NOT REMOVE!
Esta base le ayudará a prevenir que la bomba
de inflexión sobre. NO QUITE!
warning
SKU:1000 000 000 MODELO:ZE00802A
HECHO EN CHINA

Advertisement

loading
Need help?

Need help?

Do you have a question about the ZE00802A and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Everbilt ZE00802A

  • Page 1 210*60mm WARNING ADVERTENCIA SKU:1000 000 000 MODEL:ZE00802A SKU:1000 000 000 MODELO:ZE00802A • Conecte la bomba DIRECTAMENTE a una toma de tierra, nunca utilice un cable de • Connect the pump DIRECTLY to a properly grounded, 115V GFCI outlet and extensión para proporcionar alimentación a la bomba...
  • Page 2: Repair Kit

    90*130mm Repair Kit Item #3 – O-ring (Qty. 1) If you are noticing water leaking from the front of the pump, the O-ring may be worn. • To replace, using a Phillips head screwdriver, remove the 6 screws (#1), and then remove the impeller cover (#2). Remove the old O-ring (#3), and put in replacement.
  • Page 3 Quick Start Guide Read your manual for installation, operation, and safety information. This guide neither supplements Non-Submersible Transfer Pump DO NOT RUN PUMP DRY! nor replaces the Owner’s Manual. Dry running will void the warranty and damage pump. 2. Attach the clear suction hose (included) to the suction 3.
  • Page 4: Guía De Referencia Rápida

    Guía de Referencia Rápida Es importante leer el manual para obtener información sobre la instalación, la operación y Bomba de transferencia para no sumergible la seguridad.Esta guía no complementa ni reemplaza al Manual del Propietario. NO HAGA FUNCIONAR LA BOMBA EN SECO! El funcionamiento en seco, se anulará...
  • Page 5 NON-SUBMERSIBLE WATER TRANSFER PUMP...
  • Page 8    ...
  • Page 9     ...
  • Page 10  ...
  • Page 11      ...
  • Page 17    ...
  • Page 18     ...
  • Page 19  ...
  • Page 20      ...
  • Page 23 Let Us Help You ! Permítanos Help ! Do not return your product to the store. Call us rst! If you have questions regarding your product or require warranty assistance, please call our customer service toll-free helpline No devuelva su proudct a la tienda. Llámenos primero! Si tiene alguna pregunta con respecto a su producto o si necesita asistencia con la garantía, por favor llame...