Siemens SIDOOR AT12 System Manual page 19

Electric adjustment and commissioning
11. If the control signal "CLOSE" is present, the door moves into the "CLOSED" position at initial
speed. If the control signal "OPEN" is present, the door moves into the "OPEN" position at
initial speed.
12. Once the controller has detected the door "OPEN" and "CLOSED" end positions, the
subsequent opening and closing movements proceed at normal speed once again.
Note
Door movements in the "OPEN" and "CLOSE" directions can also be actuated with the learn
run button S501.
13. The door travel values can be matched to the individual door for specific applications.
This requires the Service Tool to be connected.
A PC, on which the Software Kit operating program has been started, can also be connected
via the USB adapter, which is available as a special accessory. Its operation is described in
the Appendix to these instructions.
The following settings can be made:
Function
Creep distance Open
Cutter distance Open
Creep distance Close
Cutter distance Close
Maximum speed Open
Creep speed Open
Cutter speed Open
Initial speed Open
Maximum speed Close
Creep speed Close
Cutter speed Close
Initial speed Close
Nudge speed Close
Acceleration ramp OPEN
Braking ramp OPEN
Reversing ramp OPEN/CLOSE
Acceleration ramp CLOSE
Braking ramp CLOSE
Reversing ramp CLOSE/OPEN
Continuous torque (power) OPEN
Continuous torque (power) CLOSE
Cutter press-on torque
Opening force static
Closing force static
Cutter force static Close
Nudge force static Close
18
Adjustment range
0... 100 mm
0... 100 mm
0... 100 mm
0... 100 mm
100... 500 mm/s
30... 90 mm/s
30... 90 mm/s
30... 90 mm/s
100... 500 mm/s
30... 90 mm/s
30... 90 mm/s
30... 90 mm/s
50... 250 mm/s
300... 850 mm/s
2
300... 850 mm/s
2
300... 850 mm/s
2
300... 850 mm/s
2
300... 850 mm/s
2
300... 850 mm/s
2
0... 1.5 A
0... 1.5 A
0... 5.0 A
70... 120 N
70... 120 N
70... 120 N
70... 120 N
Equipment Manual, 06/2020, A2B00086683-AD
Factory setting
25 mm
30 mm
20 mm
40 mm
500 mm/s
40 mm/s
60 mm/s
90 mm/s
250 mm/s
60 mm/s
40 mm/s
90 mm/s
150 mm/s
850 mm/s
2
600 mm/s
2
850 mm/s
2
500 mm/s
2
500 mm/s
2
850 mm/s
2
1 A
1 A
2.5 A
120 N
110 N
110 N
110 N
Elevator door drive AT12