Table of Contents
Advertisement
Servos install introduction
Install main wing servos
1.Use servo tester or radio to center the
servo.
2.Use glue to install the servo and aileron
horn on the main wing.
3.Buckle the servo cable to the through,
after installed all the servos, stick on
the decal.
4.One side pushrod insert to the servo
arm, adjust its length. And insert the
clevis to the aileron horn.
5.Repeat the above four steps, install the
other side main wing servo and flap servo.
Install the servo of Elevator/rudder
1. Use servo tester or radio to center the
servo.
2.Use screw A to fix the 9g servo on the
wood piece.
3.Insert the servo cable under the wood
piece, and put it to the battery
compartment.
Note: If you don't choose the factory servo, the
servo maybe don't fix since of its servo different size.
If like that, we need to remove the fixed wood piece,
and glue the servo in the servo position in fuselage, it
also can use in common.
Pushrod instructions
Steering pushrod size
524mm
(20-2/3")
Rudder pushrod size
96mm
(3-3/4")
Elevator pushrod size
570mm
(22-1/2")
Aileron pushrod size
55mm
(2-1/5")
Flap pushrod size
78mm
(3-1/5")
5
A - 9g servo
B - Main wing pushrod
C - Aileron horn
D - Main wing servo trough
Pushrod diameter Ø1.2mm
Pushrod diameter Ø1.2mm
Pushrod diameter Ø1.2mm
Pushrod diameter Ø1.2mm
Pushrod diameter Ø1.2mm
A
D
PWA2×8mm
C
B
Steering pushrod mounting hole
Rudder pushrod mounting hole
Elevator pushrod mounting hole
2
3
Aileron pushrod mounting hole
1
2
3
Flap pushrod mounting hole
1
2
3
B
C
A
2
3
2
3
2
3
F8F-1BEARCAT
Advertisement
Table of Contents
