Dual
Rates; Install The Loose-Leaf - Flightline F8F-1 BEARCAT User Manual

Dual Rates
Aileron
Elevator
Low Rate
High Rate

Install the loose-leaf

The surface control use no-hinge connection design, although after a lot of use, has proved to be a reliable
design. However, we don't exclude, in the use process, due to the errors, and cause the control surface fall off.
So, our package box includes one plastic pin hinge, its convenience to revise and strength the control surface.
Please refer:
11
H1
H2
H1
H2
Aileron
H1 / H2 20mm / 20mm
D/R Rate：80%
H1 / H2 25mm / 25mm
D/R Rate：100%
Step one
Use knife to cut the
surface control
Step three
As the right photo shown,
repeat the "step two", attach
the control surface to the
loose-leaf.
Flaps
Rudder
Elevator
H1 / H2 20mm / 20mm
D/R Rate：90%
H1 / H2 23mm / 23mm
D/R Rate：100%
Select the appropriate location,
cook mark. Make sure the three
points in the middle position.
Rudder
H1 / H2 16mm / 16mm
D/R Rate：80%
H1 / H2 20mm / 20mm
D/R Rate：100%
Step two
As the right photo shown, choose
two or three position, attach the
glue on the long end of loose-leaf,
and insert to the three positions.
F8F-1BEARCAT
H1
H1
H2
Flaps
H1 20mm
H1 30mm