Subscribe to Our Youtube Channel
Related Manuals for Flightline F8F-1
Summary of Contents for Flightline F8F-1
-
Page 2: Battery Installation
(www.motionrc.com) 1. This is not a toy! Operators should have some basic experience. Beginners should operate only under the guidance of an professional instructor. Before beginning assembly, please read through the instructions carefully and follow the instructions through the build. Freewing and it's vendors will not be held responsible for any losses due to improper assembly and operation. - Page 3 High speed DIY spare-parts (The following are DIY spare parts, contact your distributor to purchase these items separately) 3648-880KV brushless motor 2-blade 12x8 propeller.
- Page 4 Assembly I Wire Slots 1.Before installation, remove the battery hatch. 2.Insert the carbon rod through the fuselage. 3.insert the main wings to the fuselage. , as shown in the picture to the fuselage.
- Page 5 ation Snap and push the retainer over the clevis to the when installing the rudder pushrod, make sure that the tail wheel is centered, then adjust the clevis so that the pushrod attaches to the rudder so it is centered as well. shown in the photo above.
- Page 6 1. Use a servo tester or radio to center the servo. 2. Use glue to install the servo and aileron horn on the main wing. 3. Route the servo cables through the wiring slots. After installing all the servos, apply the covering decal. 4.
- Page 7 、 Retract servo. then the assembly...
- Page 8 the battery in the battery compartment at Using the installed tape, supplied rubberized liner and the the battery velcro strap hold the battery in place compartment hatch and remove it. ings n the side of the fuselage Note: This model comes with a slightly different control board.
- Page 9 offer airplane which can improve the flight performance. Contact our distributor for more information or to purchase this upgrade.
- Page 10 designed vents to cool the electrical components moving the battery, a suitable material such as stick on lead weight pad can be used.
- Page 11 After assembly, before the first flight, with the propeller removed, power on the radio and connect a fully charged battery to the ESC. Then use the radio to check the control surface movement...
- Page 12 plastic hinges . It design, however, the possibility, while in use, that errors causing the surfaces to tear or break may occur. we have set of s, to provide convenience if repairs are needed. to the instructions below Select the appropriate position and mark it.
Need help?
Do you have a question about the F8F-1 and is the answer not in the manual?
Questions and answers