Tips - Fujitsu SCENIC 800 Manual

Troubleshooting and tips

Tips

The PC cannot be switched off with the ON/OFF switch
Cause: The PC has not been switched on with the ON/OFF switch.
²
Press the ON/OFF switch again.
Cause: System crash
²
Press the ON/OFF switch for at least four seconds, until the device switches off.
PC switches on briefly and then off again
The power cable has been plugged in or the device was switched on with the main switch. For
technical reasons, this brief switching on and off is necessary.
Out of system resources
If you have too many applications running at once, you may experience problems due to a lack of
system resources. If this happens, you should close applications you do not require or call the
applications in a different order.
BIOS settings in power management do not become active
The Auto insert notification setting may be active for the CD-ROM drive. This setting causes
Windows 95 to inquire about any modifications on the drive at regular intervals. Because of this the
timer for the idle time cannot time out.
To activate power management, proceed as follows:
²
In Windows 95, select Start - Settings - Control Panel - System - Device Manager - CD-ROM.
²
Select the installed CD-ROM drive from the list.
²
Select Settings.
²
Deactivate the Auto insert notification box.
CD-ROM drive
Information on the CD-ROM drive can be found in the manual of the CD-ROM drive or on the
"Drivers & Utilities" CD.
Other manuals
Other manuals are contained on the "Drivers & Utilities" CD.
28
A26361-K516-Z100-1-7619