Table of Contents
Advertisement
Problem solutions and tips
Refer to the safety notes in the "Safety/regulations" manual and in the
started", Page 13
If a fault occurs, try to rectify it in accordance with the measures described in the following documents:
•
in this chapter
•
in the documentation relating to the peripheral devices
•
in the Help sections for the individual programs
•
in the documentation for the operating system in use.
Help if problems occur
Should you encounter a problem with your computer that you cannot resolve yourself:
► Note the ID number of your device. The ID number is found on the type rating
plate on the back, the underside or the top of the casing.
► Contact the Service Desk responsible for your country for clarification of the problem:
"http://support.ts.fujitsu.com/contact/servicedesk". When you do this, please have
ready the ID number and serial number of your system.
Troubleshooting
Power-on indicator remains unlit after you have
switched on your device
Cause
The mains voltage supply is faulty.
Internal power supply overloaded.
Fujitsu
chapter when connecting or disconnecting cables.
Problem solutions and tips
Troubleshooting
► Check whether the power cable is plugged
properly into the device and a grounded
mains outlet.
► Pull the power plug of the device out of the
mains outlet.
► Wait approx. 3 min.
► Plug the power plug into a properly grounded
mains outlet again.
► Switch the device on.
"Getting
29
Advertisement
Table of Contents
