Connecting The Monitor To The Line Voltage - Fujitsu SCENIC 800 Manual

Connecting devices

Connecting the monitor to the line voltage

²
Prepare the monitor as described in the Operating Manual for the monitor.
²
Plug the data cable of the monitor into the monitor port of the system unit.
²
Depending on the connector, plug the monitor power cable into either the system unit (1) or the
grounded power outlet (2).
You may only plug the monitor power cable into the monitor connector if the rated current
!
of the monitor is less than 1.5 A (230 V) or 3 A (115 V). The rated current for the monitor
is also given on the monitor itself and in the Operating Manual for the monitor.
A26361-K516-Z100-1-7619
Preparation for use and operation
1
2
13