Installing/Removing A Chipcard Reader - Fujitsu SCENIC 800 Manual

Installing/removing a chipcard reader

Installing/removing a chipcard reader
²
Open the system unit (see
Removing the hard disk carrier
²
Press on the clip (1).
²
Pull the carrier for the chipcard reader out of the system unit in the direction of the arrow (2).
Installing a chipcard reader
3
A26361-K516-Z100-1-7619
"Opening the system
2
1
unit").
2
²
Remove the panel at the front of the
carrier.
²
Push the chipcard reader board into the
guide rail (1).
²
Fix the board with the screw (2).
²
Fix the cable on the chipcard reader (3)
and on the connector for the chipcard
reader on the system board (see the
Technical Manual of the system board).
System expansions
1
41