Troubleshooting And Tips; Help If Problems Occur; Troubleshooting; Power Indicator Remains Off After You Have Switched On Your Device - Fujitsu ESPRIMO P372 Series Operating Manual

Troubleshooting and tips

Comply with the safety information in the "Safety" manual and the chapter
"Getting started", Page
If a fault occurs, try to rectify it in accordance with the measures described in the following documents:
• in this chapter
• in the documentation relating to the peripheral devices
• in the Help sections for the individual programs
• in the documentation for the operating system in use.

Help if problems occur

Should you ever have a problem with your computer that you cannot solve yourself, in many cases
you can solve it quickly using the SystemDiagnostics program pre-installed on your computer.
► To start the SystemDiagnostics program, click Start symbol - Program - Fujitsu - SystemDiagnostics.
► If a problem is detected during the test run, the SystemDiagnostics program outputs
a code (e.g. DIFS code YXXX123456789123).
► Take a note of this DIFS code and the ID number of your device. The ID number can
be found on the type rating plate on the back of the casing.
► For further clarification of the problem, contact the Service Desk for your country (see the
Service Desk list or visit the Internet at "http://ts.fujitsu.com/support"). When you do this, please
have ready the identity number and serial number of your system and the DIFS code.

Troubleshooting

Power indicator remains off after you have switched
on your device
Cause
The mains voltage supply is faulty.
Internal power supply overloaded.
Fujitsu Technology Solutions
11, when attaching or detaching cables.
Remedy
► Check that the power cable is correctly
plugged into the device and into a grounded
mains outlet.
► Check that the main switch at the rear of the
monitor is set to the "I" position.
► Switch the device on.
► Pull the power plug of the device out of the
mains outlet.
► Wait a moment.
► Plug the power plug into a properly grounded
mains outlet again.
► Switch the device on.
Troubleshooting and tips
25